DC Buck Converter Step Down DC to DC Converter 12V 24V 7-36V to 1.25-32V 12V 5V Volt Reducer Board Board Voltage Regulator Power Supply Module with LED Display USB Output & CC CV Mode

Parameters:
Input voltage:DC7-36V ;Output voltage: DC1.25-32V
Output current: adjustable, 5A Max(please use it within 4.5A)
Output power: 75W Max(please use it within 50W, if the pressure
the difference is big, please reduce power)
Working frequency: 180KHz
Conversion efficiency: Up to 96%
Working temperature:-40°C – +85°C
Installation: 4pcs 3mm screws
Module dimensions: L 68.2mm*W 38.8mm* H 15mm
description:
Short circuit protection: Yes
Input reverse polarity protection: No(if necessary, please in
input String into high current diode)
Wiring: terminal block or solder terminals, V-IN is the input,
V-OUT is output
Usage:
Use as a battery charger
Use as high power constant current LED drive module.

Note:
1. The factory default output voltage is 17V. If the module can
not be adjusted, the output voltage is always equal to the input voltage. When you encounter this problem, the counterclockwise rotation of the potentiometer is 10 laps or more, by doing this you can adjust the output voltage.
2.Because of Module output terminal string has a current resistor, it is a normal phenomenon that there will be0-0.2V voltage drop after being connected to the load.
3.When its output is more than 3A/35W, please enhance heat dissipation!
4.This DC converter is a single output, the output voltage of the USB port is the same as the output voltage of the module, if your load is a USB device, please make sure the module’s output voltage is set at 5V.
5. Single output, the output voltage of the USB port is the same as the output voltage of the module, if your load is USB device, please make sure the module’s output voltage is set at 5V.
Packing including:
1 x Buck Converter + Case