AC Pump
Air Pump
DC Solar Pump
Brushless Motor
Stepper Motor
Servo Motors
AC Synchronous Motor
Linear Actuator Motor
Audio Amplifier
Convertor Boards
Microcontroller
Motor Driver
Relay
Voltage Regulator
Charger & Power Supply
Battery Holder Case
Li-Po Battery
Lithium iron phosphate battery
Lithium-ion Battery
Solar Panel & Inverter
3D Printer Parts
Body Chassis
CNC Parts
Gears – Gearboxes
Hub – Motor – Wheel Coupler
Motor Holders
Plastic Box
Wheels – Shafts
Sensor & Wireless Module
D
Description:
This is a breakout board for Freescale’s MPR121QR2. The MPR121 is a capacitive touch sensor controller driven by an I2C
interface. The chip can control up to twelve individual electrodes, as well as a simulated thirteenth electrode. The MPR121 also
features eight LED driving pins. When these pins are not configured as electrodes, they may be used to drive LEDs.
There a four jumpers on the bottom of the board, all of which are set (closed) by default. An address jumper ties the ADD pin to
ground, meaning the default I2C address of the chip will be 0x5A. If you need to change the address of the chip (by shorting ADD
to a different pin), make sure you open the jumper first. Jumpers also connect SDA, SCL and the interrupt pin to 10k pull-up
resistors. If you don’t require the pull-up resistors you can open the jumpers by cutting the trace connecting them.
There is no regulation on the board, so the voltage supplied should be between 2.5 and 3.6VDC. The VREG pin is connected through
a 0.1uF capacitor to ground, which means, unless you modify the board, you can’t operate the MPR121 in low-supply voltage mode
(1.71-2.75VDC).
Size:3cm x 2cm .
Package Included:
1 x New MPR121 Breakout V12 Capacitive Touch Sensor Controller Module I2C keyboard
Reviews
There are no reviews yet.