XY-CD63 New 30A Battery Fully Charged Full Power Shutdown DC Under Voltage Power Loss Voltage

Note: This product is a simple voltage controller, which can turn on and off the output through a relay. It only functions as a switch, not a voltage transformer.
Function description:
1. Calculate the percentage of voltage: battery voltage / (upper voltage lower limit – lower limit voltage)
2. Key function:
Up button: short press to switch the display % and time, long press for 5 seconds to switch mode, charging mode: on, cancel mode: off
Set button: short press to display the set parameters; long press the button to enter the parameter setting interface, setting: upper voltage limit, n: lower voltage limit, p: conduction time, mcf: conduction time (0-999 seconds), rate: conduction time (0-10 seconds) in the discharge mode
Down button: press the close/open relay close/open (emergency stop operation) to close, LCD displays, and the relay is disconnected
Press the down button to set the LCD backlight mode. LP: Backlight always on, ON: Backlight automatically goes out after 5-10 minutes; After it goes out, press any button to wake up.
3. Parameter setting
a. Press and hold the SET key to enter the parameter setting interface;
b. After entering the parameter setting interface, short press the SET key to switch the set parameters;
c. After the parameters are selected, they can be set by the UP/DOWN key. Short press and long press are supported;
d. If you want to set other parameters, repeat steps b) and c);
e. After all the parameters are set, long press the SET key to exit and save
3.1 Charging/discharging time control function
When the time parameter is set to non-zero, the charging/discharging time control, the timing starts; when the relay is for charging/discharging, the timing starts; when the timing is completed, the relay is automatically disconnected to complete the charging/discharging process; If the timing is completed, the detection voltage is lower than the lower limit voltage of dn in the charging state or higher than the upper limit voltage in the discharging state, automatically turn off the charging time control function, and flash h: er to remind the user that the time parameter setting is unreasonable; press any key to stop flashing;
when the charging time control is not activated/the charging is not activated, the product will record a complete time. When it enters the time display interface, the charging time will flash; when it exits the time display interface or the next charging is activated (the relay is on), it will be cleared;
3.2 Automatic parameter detection:
When the parameters are set and output, if the lower limit of voltage dn-the upper limit of voltage up, the system will flash “err” to remind;
3.3 Delay of the transmission operation (0 ~ 999 seconds)
Interval time between the completion of charge/discharge and the re-opening;
3.4 Forced start time (0~10s) of discharge:
After the relay conduction condition is met, the relay is forced to turn on (0~10s), and the battery voltage is detected again. This function is mainly aimed at the discharge function. Some test loads will pull down to the lower voltage at the moment of conduction, which causes the relay to be disconnected accidentally, and the normal discharge process cannot be carried out;